Ageing of plasma-mediated coatings with embedded silver nanoparticles on stainless steel: An XPS and ToF-SIMS investigation

S. Zanna (1) , Claire Saulou-Berion (2, 3, 4) , Muriel Mercier-Bonin (4, 2) , Bernard Despax (3) , Patrice Raynaud (5) , A. Seyeux (1) , P. Marcus (1)

1 LPCS - Laboratoire de Physico-Chimie des Surfaces
2 UT - Université de Toulouse
3 LAPLACE - LAboratoire PLasma et Conversion d'Energie
4 LISBP - Laboratoire d'Ingénierie des Systèmes Biologiques et des Procédés
5 LAPLACE-MPP - Matériaux et Procédés Plasmas

Nanocomposite thin films (~170 nm), composed of silver nanoparticles enclosed in an organosilicon matrix, were deposited onto stainless steel, with the aim of preventing biofilm formation. The film deposition was carried out under cold plasma conditions, combining radiofrequency (RF) glow discharge fed with argon and hexamethyldisiloxane and simultaneous silver sputtering. XPS and ToF-SIMS were used to characterize Ag-organosilicon films in native form and after ageing in saline solution (NaCl 0.15 M), in order to further correlate their lifetime with their anti-fouling properties. Two coatings with significantly different silver contents (7.5% and 20.3%) were tested. Surface analysis confirmed the presence of metallic silver in the pristine coating and revealed significant modifications after immersion in the saline solution. Two different ageing mechanisms were observed, depending on the initial silver concentration in the film. For the sample exhibiting the low silver content (7.5%), the metal amount decreased at the surface in contact with the solution, due to the release of silver from the coating. As a result, aftera 2-day exposure, silver nanoparticles located at the extreme surface were entirely released, whereas silver is still present in the inner part of the film. The coating thickness was not modified during ageing. In contrast, for the high silver content film (20.3%), the thickness decreased with immersion time, due to significant silver release and matrix erosion, assigned to a percolation-like effect. However, after 18 days of immersion, the delamination process stopped and a thin strongly bounded layer remained on the stainless steel surface.

Mots clés: Plasma deposit; Surface characterization; Ageing; Silver nanoparticles; Organosilicon films

Domaines: Matériaux; Chimie analytique; Polymères; Microbiologie et Parasitologie

S. Zanna, Claire Saulou-Berion, Muriel Mercier-Bonin, Bernard Despax, Patrice Raynaud, et al.. Ageing of plasma-mediated coatings with embedded silver nanoparticles on stainless steel: An XPS and ToF-SIMS investigation. Applied Surface Science, 2010, 256 (22), pp.6499-6505. ⟨10.1016/j.apsusc.2010.03.132⟩. ⟨hal-01563929⟩